Pelling ECO

„Pelling ECO“ is semi automatic pellet boiler intended for heating of family houses and apartment buildings.

The boiler is equipped with an control unit which is regulated by flame temperature. Regulation determines the amount of pellets, which is needed to achieve the desired temperature by analyzing flame temperature . When desired temperature in the boiler is reached or received a command from room thermostat, the boiler shuts down. After the water temperature in the boiler has decreased the boiler starts up again.

The combustion burner for pellets is molded from cast iron and provides complete combustion and long life in all working conditions. Combustion is supported by a suction fan, and as a result of it ash is blown into ash pan which is located directly below the firebox. Boiler is constructed with tubular heat exchangers with turbulators that provide greater efficiency compared to conventional boilers.
Tube exchangers increase the surface of the heat transferr to the water, and also reduce the flow and temperature of exhaust gases, and therefore reduce the consumption of energy and pellet.

Pelling boiler responds to demands of the central system and can easily meet the need to increase the power due to ten different operation strengths and automatic switching. If there is a need to increase the power, the regulation system automatically increases the operation strength which leads to increased dosage of pellets and, proportionately, increased amount of the blown air in the combustion chamber.

Boiler "Pelling ECO" was created in accordance with the European standard EN 303-5: 2012, and belong to the highest class of pellet boilers - Class 5

Subsidies:

Efficiency tables

Pelling 25 ECO - Efficiency %
Full power (100 %)

91,3
Reduced power ( 30% )

92
Pelling 35 ECO - Efficiency %
Full power (100 %)

91,3
Reduced power ( 30% )

91,5
Pelling 50 ECO - Efficiency %
Full power (100 %)

91,4
Reduced power ( 30% )

91

Other information

Table of all technical data
A Učinak ( mjereno po EN 303-5:2012) J.M. Pelling 25 ECO Pelling 35 ECO Pelling 50 ECO
  Maximum power kW  25 35 47
Minimum power  kW 8 11,7 15,7
  Efficiency min / max power  % 92 / 91,3 91,5 / 91 91 / 90,7
  Electrical consumption max  W 340 410 410
  Electrica consumption stand by  W 3 3 3
  Electrical conenction (Voltage / frequency)  V, Kz 220 V, 50 Hz 220 V, 50 Hz 220 V, 50 Hz
  Electrical connection (power current)  A 6 6 6
  Boiler class 5 5 5
 
 B Emissions of the gases  
  Fume gases temperature max. power °C 155 145 141
  Fume gases temperature min. Power  °C 82 87 90
  Dust min power / max power  mg/m³  13% O2 19 / 10 18 / 10 17 / 10
  CO min power / max power  mg/m³  13% O2 139 / 68 226 / 61 314 / 54
  Mass flow flue gasses  kg/s 0,007 / 0,014 0,011 / 0,022 0,015 / 0,03
 
 C General information
  Max permited pressure  bar 3 3

3

  Max permited temperature  °C 80
  Min permited return temperature  °C 50
  Water content  l 60 90 120
  Boiler weight  kg 267 348 392
  Fuel   PELET C1 nach EN 303-5:2012 Tabele 7;  Wassergehalt kleiner 12 %
  Pellet consumption min / max  kg 1,6 / 5,2 2,3 / 6,7 3,5 / 11,1
  Pellet silo capacity standard / maxi  kg 75 / 135 95 / 151 110 / 185
  Min. entrance for fresh air  cm² 150 210 300
  Noise (EN 15036-1)  dB (A) 50,3 50,3 50,3
   
 D Technical data of the boiler and connections
  Boiler width mm 410 510 510
  Boiler width with pellet silo (standard / maxi) mm 710 / 910 810 / 1010 810 / 1010
  Boiler height mm 1245 1385 1385
Boiler depth mm 948 948 1098
  Oulet / Inlet height mm 88 / 1280 85 / 1415 85 / 1415
  Chimney draught min. Pa / mbar 5 / 0,05 5 / 0,05 5 / 0,05
  Flue pipe height (direction up) mm 1240 1440 1440
  Flue pipe diameter Ø 120 120 120
  * min power - 30 % of the  power
  * max power - 100 %  of the  power
Other
Three-pass boiler enables maximum energy yield and high efficiency.

Pelling 25 i 35 Pelling 50 ECO


Pelling ECO